Beton Deneysel Bulgular / Concrete Experimental Findings

Kürşad Türkeş

Moderator
Yönetici
13 Ağu 2019
144
24
18
YÜKSEK SICAKLIĞIN SİLİS DUMANI VE
SÜPERAKIŞKANLAŞTIRICI KATKILI
HAFİF BETONA ETKİLERİ

TR:
Bu çalışmada, bims agregası ile üretilen taşıyıcı hafif beton (HB) ve normal yoğunluklu agrega ile üretilen
normal betonların (NB) karşılaştırmalı olarak yüksek ısıya (20 oC, 100 oC, 400 oC, 800 oC, 1000 oC) maruz
kaldıktan sonraki ağırlık kaybı ve kalan basınç dayanımları araştırılmıştır. Bu amaçla, 12 farklı beton karışımı
hazırlanmıştır. Silis Dumanı (SD), mineral katkı olarak % 0, % 5 ve % 10 oranlarında çimento ile ağırlıkça yer
değiştirilerek kullanılmıştır. Kalan altı tip beton, SD’lı karışımlara, çimento ağırlığının % 2’si oranında Süper
Akışkanlaştırıcı (SA) katkı eklenerek elde edilmiştir. HB’ların birim ağırlıkları, NB’lara göre % 23 daha
düşüktür. HB’lardan % 2 SA katkılı olanlar; ilk dayanımlarının % 38’ini koruyabilmişlerdir. NB ve HB’lar, 20
oC, 100 oC ve 400 oC sıcaklıklara maruz bırakıldıklarında, NB’ların daha dayanıklı oldukları görülmüştür. 800oC
ve üstündeki sıcaklıklarda, SD kullanım oranına bağlı olarak basınç dayanımı kaybı artmıştır.
Anahtar Kelimeler: Hafif beton, bims agregası, yüksek sıcaklık etkisi, silis dumanı.

ENG:
EFFECTS OF HIGH TEMPERATURE ON THE LIGHTWEIGHT CONCRETE
WITH SILICA FUME AND SUPERPLASTICIZER
ABSTRACT
In this study, structural lightweight concrete produced by Pumice and normal-weight aggregate concrete are
investigated in terms of compressive strength and weight loss of Concrete with Pumice Aggregate (PAC) and
Normal-weight Aggregate (NAC) after being exposed to high temperatures (20, 100, 400, 800, 1000 degrees C).
For this purpose, 12 different types of concrete mixtures were produced. In producing the NAC and PAC
mixtures, a mineral additive, Silica Fume (SF), was used to replace the Portland cement in the ratios of 0 %, 5 %
and 10 % by weight. The remaining six types of mixtures were obtained by adding Super Plasticizers (SP) to the
mixtures with SF in the ratio of 2 % by weight. In conclusion; unit weight of PAC was 23 % lower than that of
NAC. The PAC containing 2 % SP could retain 38 % of the initial compressive strength. When exposed to the
temperatures of 20 oC, 100 oC and 400 oC, NAC performed better than the PAC. The loss of compressive
strengths increased depending on the ratio of using SF at about 800oC and over.
Keywords: Lightweight concrete, pumice aggregate, effect of high temperature, silica fume.

Rar Password:
Bu linki görmek için izniniz yok Giriş yap veya üye ol.
 

Ekli dosyalar

  • beton hakkında deneysel bulgular.rar
    262.8 KB · Görüntüleme: 0
Geri
Üst