Mazatrol 640T EIA ISO

[Emrah Burulday]

Mazatrol 640T EIA ISO

1 INTRODUCTION ..................................................................................... 1-1
2 UNITS OF PROGRAM DATA INPUT....................................................... 2-1
2-1 Overview.............................................................................................................. 2-1
2-2 Detailed description ............................................................................................. 2-1
3 DATA FORMATS..................................................................................... 3-1
3-1 Tape Codes ......................................................................................................... 3-1
3-2 Program Formats ................................................................................................. 3-5
3-3 Tape Data Storage Format .................................................................................. 3-6
3-4 Optional Block Skip.............................................................................................. 3-6
3-5 Program Number, Sequence Number and Block Number : O, N......................... 3-7
3-6 Parity-H/V............................................................................................................. 3-8
3-7 List of G-Codes.................................................................................................. 3-10
4 BUFFER REGISTERS............................................................................. 4-1
4-1 Input Buffer .......................................................................................................... 4-1
4-2 Preread Buffer ..................................................................................................... 4-2
5 POSITION PROGRAMMING................................................................... 5-1
5-1 Absolute Data Command and Incremental Data Command: G90, G91 .............. 5-1
5-2 Inch/Metric Selection Commands: G20/G21........................................................ 5-2
5-3 Decimal Point Input.............................................................................................. 5-3
6 INTERPOLATION FUNCTIONS .............................................................. 6-1

[Detailed description]
- The instruction shown above performs the same function as that of the instruction below.
G65PMm; (Mm is not outputted.)
- Use parameter to set the relationship between Mm (macro call M-code) and P
(program number of the macro to be called).
Up to a maximum of 10 M-codes, ranging from M06 to M255, can be registered. (Parameter
K89 to K93, P43 to P47 and P51 to P55)
Do not register the M-codes that are fundamentally required for your machine, nor M00, M01,
M02, M30, and M96 through M99.
- M-codes and MF are not outputted.
- If registered auxiliary command codes are set in the user macro subprograms that have been
called using M-, S-, T- or B-codes, macro calls will not occur since those special auxiliary
command codes will be handled as usual ones (M-, S-, T-, or B-codes).
5. M-code subprogram call
The user macro subprograms of the preset program number can be called just by setting Mcodes.
(Only the registered M-codes can be used.)
Format:
Mm;
M-code which calls macro-subprogram
[Detailed description]
- The instruction shown above performs the same function as that of the instruction below.
M98P; (M98 is not outputted.)
- Use parameter to set the relationship between Mm (macro call M-code) and P
(program number of the macro to be called).
Up to a maximum of 3 M-codes, ranging from M03 to M255, can be registered. (Parameter P57
to P62)
Do not register the M-codes that are fundamentally required for your machine, nor M00, M01,
M02, M30, and M96 through M99.
- M-codes and MF are not outputted as well as M98.

Rar Password:

Bu linki görmek için izniniz yok Giriş yap veya üye ol.